Collapsible Deck Holder

This deck holder can hold standard size cards stacked up to 94mm tall. The spokes can be taken apart and slotted inside the base, allowing for a smaller storage footprint.

Deck Holder-Base.step contains the base. To avoid difficult-to-remove supports, it has to be printed in a weird 45 degree angle as shown in image 4. It is thus prone to falling over during printing. A brim is required. Using glue is also strongly recommanded.

Deck-Holder-Wall.step contains the 1 spoke, you will need to print 2, with one of them mirrored.

Or you may use the provided 3mf file with the settings pre-applied.