PSVR2 DAS Mount

These pieces are designed to make it straightforward to attach a Vive DAS to a PSVR2, using M3 nuts/bolts or hot glue/VHB tape.

The stock facial interface needs to be unscrewed for the custom interface to take its place, the visor must be removed, and the cable separated.

The left and right clips are mirrors of the “clip” model and can either be hot glued or bolted onto the sides. If you decide to open the headset and drill it, the nut bar can be adhered on the inside, so it will not be required to open the headset again to make adjustments. The side pieces should be attached perpendicular to the lenses, so pressure is even across the face.

The face side of the facial interface is designed from the AMVR Quest 3 facial interface, however foam from other aftermarket facial interfaces should still work.