Nintendo Switch Lite Holder Stand

Wide Holder Stand with minimal wall thickness.  Designed to hold a Nintendo Switch Lite with or without the charge cable plugged in.  Smartphones and Small Tablets also fit well on this stand.

Print Placement and Settings:

1. Place stand on its side on the print bed (See Photo for Orientation)
2. Set Support Settings to Auto, Organic, and Support on Build Plate Only
3. Infill pattern Gyroid or Crosshatch. Fill Density/Infill Percentage around 12% works well

Optional Settings

1. Add some weight: Create a modifier block for the “bottom” of the stand.  Set the fill density to 100% infill. This will add weight to the bottom. Giving a sturdy and planted feel
2. Set an Outer Brim to 5mm to maintain Bed Adhesion throughout the print