Pi Camera mount (not official camera)

I bought a Pi camera: https://www.ebay.co.uk/itm/Raspberry-Pi-Wide-Angle-Camera-Module-Pi-Zero-Cable-Included/153078067107

However the standard Raspberry Pi camera mounts will not fit this, so I created my own. The camera module slides in and is a tight fit - but this means no screws/glue are needed.

For the bracket, I use the one from here: https://www.thingiverse.com/thing:2886101

The camera stays in place because the two small screws on the back fit into the holes - its a tight fit to get them in there, but means it wont fall out.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

20%

Notes:

I use a brim as its best printed with the open end up for better adhesion.

How I Designed This

Rough version

Used a calipers to measure the module that I had - in Fusion 360 just made a clip that would hold it and use the back screws to keep it in place.