NanoPi NEO3 under desk / wall mounting enclosure

This enclosure is designed to mount the NanoPi NEO3 under a desk or on a wall.

Difficulty Level: Advanced

• A heated chamber is highly recommended.
• Brass hot melt inserts require careful installation.

Preferred Printing Settings

• Material: ASA (tested), ABS
• Infill: 30% rectilinear
• Perimeters: 3 (1.2mm)
• Layer height: 0.1mm
• Solid layers: 12 (1.2mm)
• Supports: not required
• Nozzle diameter: 0.4mm

Additional Components Required

• Four M3 x 5mm Brass hot melt inserts (4.2mm OD)
• Four M3 x 12mm hex socket or decorative head screws
• Four M3 x 12mm screws with a small, flat-bottomed head
• Four M3 nuts

Additional Tools

• Heat-Set Insert Installation Tool

Warnings!

• Do not use countersunk head screws! Use only screws with a flat head on the bottom.
• There is very little free space on the PCB around the mounting holes. For this reason:
  • Be sure to carefully check that the screw heads are not too large.
  • Confirm that there is sufficient space around all mounting elements.
  • Assemble the PCB to the mounting frame very carefully to avoid damaging the components.

Notes

• Brass hot melt inserts must not protrude above the surface. 
  If precise placement is a problem, it's better for them to be slightly recessed than to stick out.
• Due to limited free space, the mounting holes in the PCB mounting frame are designed with very little clearance - if they turn out to be too tight in the printout, they can be slightly filed out.