RPG Flying Stand

Square platform for placing a 25mm wide mini above another one for D&D or other TTRPGs. The riser is 58mm tall and meant to represent 10 ft in D&D.

This was inspired by multiple other designs I've seen online, but I modified the vertical wall to curve around the sides a little for added strength when you press on the top platform. Note that the entire stand is slightly larger than a 1" grid (about 30mm wide), so it will not fit if you need to use a bunch of these side-by-side.

Does not need supports if the vertical part is oriented flat on the print bed. 2 walls and 10% infill is plenty strong to hold miniatures. Tested in PLA only.
 

Changelog

• 8/21/2025: Added v2 with a lip cut out of the bottom to be stackable