SOVOL SV06 ACE Relocated duct for Volcano Nozzles

This model was created specially for using with Volcano nozzles, but it works just fine with original (proprietary) sovol nozzles.

NOTE!
You need to extend the cable for about 30-40mm so it reaches the connector

It is recommended to print this model with heat-resistant filaments like PETG or ABS.

I printed this model with such settings, but I will appreciate if you can fine-tune it:

Supports: YES, Normal, auto (make sure that there is no supports inside)
Wall loops: 4
Top shell layers: 4
Infill: 15%


Please feel free to remix this model.