Stealthchanger Stealthburner backplate v1.1 magnet mod with screws for all pins

*********************************UPDATE**********************************

I HAVE UPDATED FOR STEALTHBURNER - I TILTED THE TAP MOUNT 2 degrees back and added a little strength supports for it.

I was having an issue where the screws that mount the SB on this backplate would pull the tap mount up. I have countered this by angling it back by 2 degrees, it seems to work good so far. USE AT YOUR OWN RISK.

****************************************************************************

just stitched 2 mods together cant take credit for this....
these are untested printing as i post this
lowered wiper too

combined both of these two mods. one for magnets the other for all pins being screwed in. I cant take credit. i just cut and stitched them together. I am printing them now. I have not tested them yet. I am a little worried about durability.

I also lowered the wiper mount for the bambu style wipers.

for stealthburner on a stealthchanger…

NO SUPPORTS NEEDED…..Removable support is built into the backplate.

JUST PRINT TO VORON SPEC

used this as well

https://www.printables.com/model/1358108-stealtchanger-stealthburner-backplate-with-screwed

combined both of these two mods. one for magnets the other for all pins being screwed in. I cant take credit. i just cut and stitched them together. I am printing them now. I have not tested them yet. I am a little worried about durability.

I also lowered the wiper mount for the bambu style wipers.

for stealthburner on a stealthchanger…