Flashforge Adventurer 5M (AD5M) Lid hinge

Simple hinge so you won't have to fiddle with the lid anymore.  

Print in place, no supports needed. Takes 4 PC fan screws per hinge. You need to drill 5mm holes to the lid. Alternatively you can use strong double-sided tape.

CAUTION: Be careful not to overtighten when screwing it to the back of the enclosure top, it doesn't have lot of strength there but it's sturdy enough to keep it in place. You can also put a dab of CA glue to bond the hinge to the enclosure properly.

I printed mine in ABS and 0.20mm layer height. PETG should be fine too.