Hex Key EZ Handles Long [Remix]

I really liked this model by the author BaGooN, both from a design and a practical standpoint. However, it seemed to be primarily intended for smaller hands. Fortunately, the author also provides a STEP file, so I decided to slightly extend the handle, by about 20 mm.

Print instructions:

• Material: PLA
• Used Filament: Prusament PLA Gentleman's Grey (body)
• Layer: 0,15 mm
• Perimeters: 2
• Infill: 25%
• Infill Pattern: Grid
• Supports: No
• Brim: Recommended

This model requires some special settings, more details in the attached 3MF file.

Custom modification:

If you want to modify the model, I am attaching the STEP file and a link to my OnShape.

OnShape Link

Current model version: 

V01

Note:

Please don’t forget to leave a comment and rating. I truly appreciate any feedback – it helps me improve and address any potential shortcomings in the model. Thank you very much!

Print visions, create reality!

The handle has been extended by approximately 20 mm.