Turbo-Vase+

Updated files, 01/14/23.   Repaired mesh files.  Recommend using with “REPAIRED” in the filename, and ignore others.

I printed this one "fast" out of ABS using .3mm layers. I took about 2.5 hours. I do not usually use a fan on ABS but I used 50% on this on because I did not use support, and some of the vanes were not cooling fast enough in the first 25 layers. After that, I turned the fan off. Used Simplify3d. Hard to make the leap because of cost, but I am now glad I did!

I will probably try it in clear PLA or ABS next. Makes it look good in a window.

Try stretching + and -  in X or Y to get some different effects.

I added another vase, #7. I will take awhile to print. Like about 3 hours and 45 min.

Added vase8A which should print faster than vase8 and has a different curve and transition towards the top. It was meant to replace the original, but I decided they both have virtues.

Category: Sculptures, Decor, Vase