Small baoding ball stand

Small 25mm x 25mm x 5mm ball stand to keep decorative balls from rolling around.

Initially this stand was created for ~50mm diameter decorative stone balls. 

Printed with PLA and 0.15 Structural Core One default settings.

• Layer height: 0.15mm
• 2 perimeters
• 15% infill
• Material PLA, should also print in other materials without problem.

Uses about 1.7g of material and prints in about 7 minutes (I made 2 at once and used 3.6g of PLA with 14 minutes print time).

Could also try to turn ironing on for smoother transitions (if it helps at all). I tried but with PLA and heat creep had problems with material feed, probably should increase ironing speed to make it faster and avoid heat creep