ThermoWorks Pro Series Probe Mount Magnetic
Modified probe mount to include two 8X3mm magnets
1
2
0
16
updated
August 10, 2025
Description
PDFHad difficulty getting double sided tape to stick to the textured surface on the interior of my upright freezer so I modified the base to accommodate two 8X3mm magnets.
Very quick print, less than 10 min.
Magnets holes are sized 0.1mm over to allow for shrinkage, but still should fit snug enough to not need glue.
Probe hole is friction fit and should hold at any angle
No supports required
Model origin
The author remixed this model.
Differences of the remix compared to the original
Modified original to accommodate two 8X3mm magnets