Wahl Clipper Guides 12 and 16 (1.5 inch/37mm and 2 inch/50mm)

These are two Wahl clipper guides in 2 inch (50mm) and 1.5 inch (37mm) sizes.

Should work with most 1.87 inch (47.6mm) max. wide Wahl style clipper blades.

They are intended to be used with the clipper horizontally, on the side parallel to the cutting head plates, but when used with the clippers vertically, the hair length will still be maintained.

The orientation for printing should be as shown above in the .stl files to print properly with minimal support required.

I have also included the gcode for using PETg on a Prusa MK3S, in case that is what you are using.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

Yes

Resolution:

200

Infill:

20

Filament: PolyMaker PETg

Notes:

I used .26 layers and the .3 fast draft speeds. You need some support under the the tip of the latch. Some slicers, including PrusaSlicer, will do that automatically if you set it that way in supports. In my case, I painted in where I wanted the support with PrusaSlicer 2.3. I set the offset for the supports to .1mm. 4mm nozzle. 85-90C bed, 235-240 nozzle.
I used [Polymaker](https://www.amazon.com/PolyLite-Printer-Filament-PLA-2-2lb/dp/B01IAVQIWE?dchild=1&keywords=polymaker+filament&qid=1618268031&sr=8-3&linkCode=ll1&tag=thingiverse09-20&linkId=4324f80ce0a8d9e2bed8c93f7135c03f&language=en_US&ref_=as_li_ss_tl) PETg 1.75.

A little cleanup may be required on the radius touching the print bed to smooth it out.

I had originally included all the size stamped into the surface, but it just slows the print down. The two are noticeably different form the #8 guide that you should be able to tell what the sizes are just by looking a them. I do not consider #10 or #14, 1.25"/32mm or 1.75"/44mm, useful, so don't bother asking.