X Shot Motorized Piston Pump 'Terrier-K/M/XL' short and long handguards

IMPORTANT UPDATE:
DON'T PRINT version 1.01 of the XL handguard. There was an issue resulting in a 3mm gap towards the rear. Please print the new 1.02 version instead. This issue doesn't affect the M and K versions.

Handguards for the Motorized Piston Pump by XShot. Inspired by the HK433.
There is picatinny on the 12 o'clock position and usable M-LOK on the sides and bottom.
Slide over the barrel collet from the front. 2 bolts clamp it down. 
.stls come pre-oriented. .stp files are included. Prints without support.

Original: 210mm long
K (Kurz) - Shortest version; 130mm long
M (Medium) - Sligthly shorter than original; 170mm long
XL (Xtra Long) - Longer than original; 250mm long (231mm print height required!)

REQUIRED HARDWARE :
- 2x M5x30mm socket head screw
- 2x M5 Hex nuts (Nylon lock nuts recommended) 
 

Short and long versions.