Snapmaker 2 external enclosure screen mount
Remixed version to have a tighter fit and mount the screen completely vertical without tilt
0
4
0
12
updated
August 10, 2025
Description
PDFI had some issues with the original design beeing a little to loose and angled to much so i created a new version which has quite a tight fit (Be sure your printer is calibrated well) and the screen is mounted completely vertical without tilt.
Printed in PLA-HS Textured Gray from Anycubic
0.2mm layer height on its side without support
3 walls, infill 15% but I think it's negligible.
Parts needed:
2 x M4x10mm screw
2 x M4 Nut
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
Tighter fit + vertical mount without tilt