Imprisoned Can Holder

This was submitted for the Can Holder contest.

Styled like a prison but functional like a mug, including a spot at the top for a spinny fidget bit to play with while holding your can (see gif). Remind your can where it belongs!

I printed my models with PETG, with painted on supports for the handle in some areas. I'm not sure if it's necessary to use supports, so if you're brave enough to try without, let me know! There's another model without a handle if you don't want one. I don't have PLA or other filaments, but I don't expect any trouble with other filaments.

To put the “gear” on the tower, align it with the top of the tower, then push down. It should slide in to the groove at the top without much trouble at all. Then you can freely spin it around all you want!