Gameboy Zero 3.5in DPI Screen Bracket and Volume Mounts

This is remixed from the 3.5" Composite Screen Bracket from PocketAdventures.

In a recent build I used a DPI adapter from TinkerBoy and a Volume Assist Board w/ USB from PocketAdventures. The original design needed to make room for the DPI adapter plate and allow for the Pi Zero SD card slot to fit up to the contrast port.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

Yes

Supports:

Yes

Resolution:

0.2

Infill:

20-30%

Filament: Hatchbox PLA White Post-Printing =============

Drill Out Pi Zero Mounts

With 0.4mm nozzle, you'll likely need to hand drill out the holes for the Pi Zero mount on the contrast port side. I use a 2mm bit and very short screws.