Small Curved Voronoi Lamp Shade

Updated STL uploaded an older version without a flat bottom accidently.

Smaller voronoi lamp shade with a more curved design than my last and smaller.

~200mm wide x ~100mm tall, 30mm hole for lamp holder.

This one has slightly thinner strands and more holes.

Like the last one work well with translucent filaments, looks quite cool if you swap filaments a few time throughout the print too.

Print out of heat resistant filament (ABS,ASA etc.) or use low wattage LED bulbs so should it be safe with PLA/PETG, i.e. don't be stupid and burn your house down.

On a fast printer should print in around 10 hours @0.2, and is a bit more of a overhang retraction test than the thicker one and you need reasonable cooling to stop the edges curling up.

Category: Decor