A quick cable clip to complement the pool robot cable holder published previously.
Its another parametric OpenSCAD design so you should be able to adjust and customize it fairly easily for other cable sizes if required. The provided gcode fitted the ~7mm power cable on the pool robot quite nicely. The design should print without support.
I was hoping that the grooves on the surface would act a bit like a kerfed surface and allow the print to flex just a little. The clip works fine but I haven't tweaked the design at all and I suspect that the grooves on the front and rear surfaces might not align that well if printed at other cable sizes. I added the "finish" parameter that allows the surface texture to be disabled if required. Disabling the grooves will also probably produce a faster print however the print-time is not unreasonable as-is.
Just three design parameters to play with:
The author hasn't provided the model origin yet.