EXEN Orca Custom TPU Prints

Everything should be printed out of TPU with supports.

• The Buzzer holder is for a Vifly Finder 2
• The Capacitor holder fits a 10mm polymer capacitor with a TVS array attached (I use Unicon 1000uF low ESR capacitors with a Fettec spike absorber)
• The Front antenna holder holds a thin ELRS antenna, I use HappyModel ones
• The O3 holder has a holder for a 2nd ELRS antenna since I tend to run HappyModel EP1 Dual receivers
• The RX holder can hold a HappyModel EP1 Dual, or a Radiomaster RP4TD with a bit of heat to let the tpu deform a bit.
• The rear pod is designed to hold an XT60-H (the ones with the little flange), and the antenna holder is designed for linear whip antennas.