There's A Ghost (glowing) In My House Remix with Magnets

This is a remix of djedje_zr7's There's A Ghost (glowing) In My House, the original requires screws and nuts.  I did not have them but I had a bunch of 8mmX3mm magnets so I redesigned both pieces to use magnets instead.  Six 8X3mm magnets are required for this model, I had planned to glue the magnets in place but I was able to press fit them on my prints.  Make sure you have the magnets facing the right way before pushing in, it does not look like they will be able to be removed easily.

Printed with Hatchbox PLA, please note I did have a hole on the shoulder of my ghost but I believe that was due to my live adjust z height being too low and not the model itself.