Billy Billy Coat hanger

Have you ever looked at your coats and thought – damn, I really wish they would be perfectly spaced apart? 

Then this print is for you!

You can use it two ways:

1. Just print the spacer and put it on your existing 25mm pipe. 
   There are 3-piece and 2-piece modules, combining them you can upgrade any rack of your choice, be it 1 meter, 1.5 or 5.
2. Print left end, right end and your number of MAIN_SPACER. Everything screws together to make a seamless rack for your clothes, completely repacing the existing hanger.
   These items should be strong enough up to 5 meters, however, by using nylon you can extend them indefinately.
    

Every model should print without supports, although, if you have poor bed adhesion, you might want to add brim or a thin line of supports somewhere in the middle.

And that is pretty much everything! Share your prints and have a nice day.