Unfolded Circle Remote 3 wireless charging stand

A wireless charging dock for the Unfolded Circle Remote 3 that can accept MagSafe (56mm) or third party (58mm) wireless chargers. The base and cover are universal; just pick which cradle charger size you need and print accordingly. I have included a blank so you can modify with your own cutout if needed.

This is a press-fit 3 piece design, so please note that you will need to dial in your filament, infill, printer and nozzle settings to ensure proper fitment.

I have included test fitment files so you can dial in your settings with minimal filament waste. I suggest printing with tree supports (critical regions only) with the charging stand facing upward (rot x=-75) and the base facing downward (rot x=105) for best results.

ASSEMBLY:

1. Place the wireless charger into the circular recess of the charging bed, making sure the charging element is flush with the charging bed while threading the cable into the channel.
2. Align the pins on the back of the charging bed with the dovetails on the base and slide the base upward, making sure to keep the power cable in the center channel. Work the base upward about ¾ of the way up the charging bed. It should be a snug fit. 
3. Thread the charging cable taut around the bottom of the charging base's cable channel and out the back, then attach the base cover by aligning the matching pins, then firmly press flat to click the base cover in place.
4. Work the charging base upward until the gap disappears and the entire unit can stand flush.

NOTE: The base, stand and cover should fit together snugly with the dovetail joints and may require some gentle force to assemble. Likewise, the charger should fit snug into its recess. However, the Remote 3 should fit loose on the stand.

CAUTION: You should not have to force the remote into the cradle. If the Remote 3 does not slide into place freely without any friction, DO NOT force it in place or you may damage your remote. Please check your print settings.

UPDATES: 

• Added support for the wider TPU variant of the unfolded circle remote 3 V2 slim case.
• Added a spacer to the MagSafe variant after noticing that there are slight changes to the 2025 Apple MagSafe charger.
• Butcher block flat variant added for better ergonomics. Includes its own base, base cap and 3 sizes. Please note that the Anker version is untested because I do not own that wireless charger.
• Added support for Jake's unfolded circle remote 3 V2 slim case.
• Added v2 of the base and base cover with a deeper and more rounded cable channel for better cable routing.
• Added support for Anker wireless charger (59.88mm). You will need to print the Anker base with it. Please note this is untested, I do not own this charger and cannot confirm fitment. Please let me know if it needs modification.