Orbiter 2.0 mount for Prusa mini mosquito mount

This is a remix of my orbiter 2.0 mount for the Mini.
which is a remix of Paul Chase's 1.5 mount

This has been modified to fit the Mosquito mount found here. https://www.prusaprinters.org/prints/37387-mosquito-mount-for-prusa-mini

E-steps can be set in the official mini firmware
the E-step value is 690

added to starting Gcode as the mini will not save these settings

;start orbiter settings
M201 E10000 ;acceleration mm/s2
M203 E120 ;max speed mm/s
M205 E5 ;E jerk mm/s
M906 T0 E850 ;TMC motor RMS current in mA
;end orbiter settings

the official LDO motor runs at 850mA

Printed on my Prusa mini+ with SunLu White PETG with no supports
Infil: 15% .20 layer height with a .04 Nozzle