Large Phone Charging Stand

This phone charging stand has a place for a phone, and an AirPod case to charge along with an optional place for an apple watch. The AirPod spot is larger enough to fit AirPod cases with additional cases on them and the home for the chargers should be larger enough to fit most cables though then. Your phone will fit on this stand both portrait and landscape mode.

There is a separate file if you do not want the apple watch attachment. 

If you do want the apple watch attachment then you will need to print both the apple watch attachment and the phone charger stand. Then once both are printed super glue the apple watch attachment into the sot on the back of the phone stand. There is a space for a 6mm magnet in the Apple Watch charger attachment(you will need to superglue the magnet in). The magnet helps your charger stay in place better but it should still work if yo don’t have a magnet. 

When printing I would recommend printing the stand on its side with supports for only the slot wear the phone goes.