Hotend mount for the e3d v6 on the Tevo Tornado

Hotend mount for the e3d v6 on the Tevo Tornado, it might also work with the CR-10 but I did not test that.

I switched from my anet a8 to the tevo tornado and I missed the e3d hotend (I had a e3d v6 on my anet). The printquality of the e3d v6 hotend is just a tiny bit better than the original one.

I used the frame-piece of "DemolitionX" and slightly modified it so you can mount a BLTouch sensor to it. I used the BLtouch mount of "gdramos". So the BlTouch offsets are;

• x=42,5mm
• y=12,5mm
• z=0mm

The marlin software can be downloaded here:
https://www.dropbox.com/s/lfg2wd5sq3f0wtw/Tornado_Firmware_Updated.zip?dl=0
installation guide:
https://www.youtube.com/watch?v=mBwHGuX5de8

Hardware:
Original screws
e3D v6+BlTouch (of course)
5015 Blower fan

Print:
1x e3d v6 mount with BLTouch_fixed.stl
1x e3d_v6_modular_fang.stl

I also included the version without the BlTouch