Skoda Yeti USB AUX panel (MDI panel replacement)

I my Skoda Yeti I had a MDI connector for connecting audio devices.
This interface is outdated and unusable for me since I installed an after market head unit.

I made a replacement panel in three versions:
- A blank panel without holes
- A panel with a hole for a square snap-in USB port
- A panel with a hole for a square snap-in USB port and a round 3.5mm AUX port

The panel can be fitted with two short M3 screws and an (optional) M3 screw in the middle using the 'washer' STL. (of course you need to remove the cubby)
No changes/drilling is needed in the original dash, everything can be reverted to stock.

Both the holes for USB and AUX are recessed for a clean look.
Note that on the back of the panel, outlines are visible of the maximum aperture that would fit in the dash, as well as a center guide for drilling a round hole for an AUX port. This is very convenient when you decide to print the blank panel to customize yourself.

I included photographs of the two ports I ordered at Aliexpress 
You should be able to find these searching on Ali for "USB 3.0 Male to Female AUX Flush Panel Mount" and "PJ-392A 3.5mm Audio Jack Socket"

Fits Skoda Yeti 2009-2017, and maybe other VAG/Volkswagen/Audi cars with a similar panel

Note:
Print in heat resistant material like ABS or ASA, PLA will deform in a hot car!