Air intake for canister

Air intake for canister

• use wire for install screw to canister
• make hole with 10mm drill bit
• use 13x3mm gasket
• print gasket with TPU for best seal
• On cap is small eye for cord to dont lose it ;-)

Print settings

• 0,2mm layer
• 6 walls
• 100% infill
• print like it is for best durability (othervise thread can break)
• use normal supports 25°threshold angle for screw part (its oriented like this for best durability)
• gasket print with TPU
• other pars with PLA or PETG… I think you can use what ever you want