Elegoo Saturn 4/Ultra/16k Drip Handle

I wanted a drip bracket integrated into my build plate so that I didn't have to hold the dripping build plate with one hand and try installing the bracket with the other, but the double sided ones that I found didn't have clearance for the S4U 16k build plate handles. This one also tilts the build plate 5 degrees to the rear corner allowing the resin to drain better and allowing you to tilt the build plate that direction during attachment to reduce the chance of dripping outside of your vat. The bracket also allows you to set the build plate upside down on a table.

You do have to remove the handles to install. Reinstalling the handles locks in the bracket into place in addition to the two screws on the build plate.

(Update): Trimmed to resolve the senor error. (I had tested with my clip-on handle that lifts my cover ~3mm, and I didn't notice the error originally)

Took the aspects of both designs and combined them to make the double-sided drip handle that works with S4U 16K handles to make it more secure.