Multiboard Paper Towel Holder

Overview

  A complete print in place paper towel holder for the Multiboard system.  It will require four snaps. Push-Fit, Bolt-Lock and Pegboard Click options available. It's a good idea to have access to the back of your board if you use the Bolt-Lock option. The Bolt-Lock option requires 4x Small Thread Lite Multipoints and 4x raised snaps. I would personally avoid the push-fit option as it is not the most reliable in my findings.

New to Multiboard? Start HERE. It's free!

                                                                               *gif courtesy of  Jungl3 

Printing

Print in place. I use an outer brim for added bed adhesion. I do not recommend the push-fit option. 

Nozzle: .4

Filament: PLA/PETG

Layer Height: .2

Supports: No

Infill (%): 10%

Build Plate Adhesion: Yes. Outer Brim.

Take a look at my other Multiboard add-ons, or any of my Spooky Items while you are here.

Like my work?

❤ a few of my models

and

Follow Me

Special Thanks:

KeepMaking for creating Multiboard

Jungl3 for creating the Paper Towel Holder and the borrowed gif

Edits:

7/30/25 | Error in direction of push-fit was addressed. This should not effect most who have downloaded already. Bolt-Lock option added.

7/31/25 | Pegboard click option added. Bolt-Lock option updated.

8/1/25 | Few small edits for QC. 

I adapted one of the best paper towel holder models to use with Multiboard as per the Multiboard License.