Fairphone 6 Case - no TPU

I found other cases to be a bit bulky and printing TPU is always a bit of a pain, so i made this slim, lightweight PLA case. It's 12g and can be printed without supports (i do use organic supports for the usb and speaker cutouts though). No button gets covered. Pretty much every edge is chamfered, as to not feel too sharp on the hands. 

PLA/PETG recommended. TPU will probably turn out too flimsy.

To get patterns on the backside:

set Top/Bottom layers to 0.

Recommended patterns: Honeycomb, Gyroid

Depending on your printers accuracy you may need to scale the model a tiny, tiny bit (like +/- 0.1%) to get it to fit snug. 

Lemme know what you think. :)

edit: 

• New Version V2 with a much bigger charging port cutout. Now every charger should fit.