Can Washing Station

Do you live in a country with a can deposit? Do you wash your cans so when you go to deposit them you don't have gross sticky stuff on your hands? Me too.

Here's a 3 piece washing station. Place it anywhere in your sink, load up 4 cans, fill em with water, then flip the cans upside down to drain them. No more awkward holding of only two cans in your hands, or playing can-jenga so they can stand upright in your sink.

Works with 500ml, 330ml and slim 330ml cans.

The support hole is oversized by 0.2mm. The support's clips are very solid and probably overkill. It's a separate piece because I don't trust my bed-slinger to print it upright.

Thanks to my obsession with fillets, the overhang should be fine to print without any supports. It's about a 1 hour 30 print total on my SV07 with 0.3mm layer height.