DeWalt DCV517, DCV580 Vacuum Hose Attachment Tools or other hose end around 32mm or 1-1/4"

I bought this DeWalt DCV580 at a thrift store with only the hose. I needed attachments and made these with a way to store the extras.

Crevice Tool: Similar to the original and also clicks into the DeWalt handle for storage and will not fall out.

Wide Tool: Not as wide or large as the original but should concentrate more suction due to the smaller size. Will clip into the original spot.

Extension Wand: Sometimes you need a little longer length for the hose, especially for the DVC517 unit. Length is about 7-½" or 190mm. 

Narrow Tube Tool: Use for getting into a smaller space that the crevice tool will not. For storage it will fit into the crevice tool end or the extension wand.

Wand Clip: Clips onto the DCV580 carry handle and allows the extension wand to be held on top. Printing two would be preferable.

I used a generic black PLA on an Ender 3 with a PEI plate, 0.20 layers, 3 walls, 25% infill. I printed with an inside and outside brim.

Update 1/16/26: Over time I did not like the way the clips worked. The new clips are thicker, fit tighter, and sturdier. After printing the pieces, screw the clips together with the rod. Insert sideways on the vacuum handle and tilt up into position.