TUNIC Sword - No glue

I separated rhynes' model into different pieces and modified them so the prints can be printed in their respective colors and then put together with no glue.

It's possible to print this sword bigger than rhynes' version because the print size is now only limited by the blade's size and not the size of the whole sword.

The blade now has a tang which keeps it inside of the hilt, and there are notches in the hilt and pommel. The gem stays in because of friction.

This was my first model, so it's not perfect and there will be a gap when the hilt is put together unless the sword is sanded.

There are two ways to print the blade, each with their pros and cons:

1. The full file of the blade
   • Looks super nice when printed standing up
   • Has the least obvious layer lines
2. Print two halves of the blade
   • Can be printed ~1.4 times bigger if printed diagonally (which allows a bigger sword overall)
   • But requires 2 to be printed
   • Has 2 notches for pins to align the halves perfectly
   • Requires 2 more pins
   • The point of the blade can pull up from the adhesion plate and mess up the point

There are also 2 handle, Handle.stl is an accurate length and Long Handle.stl is slightly longer because I wanted to comfortably grip my sword printed on a 255 mm size printer.

I split the parts that should have different colors into different parts, and then added pins, notches, and parts that fit into another so the sword can be put together without glue.