NFT Ape Vape to Battery Charger

NFT Ape Vape to Battery Charger
This is a model to make a NFT Vape into a battery charger for 3.7v

To make this charger you have to first:
 

1disasamble the vape and take out the inner pc without damaging the usb port or the screen

2then solder 2 female wires to the plus and minus cables of the pcb and then stick them into the holes of the case

3lastly put a ton of stuffing inside or something like hot gule to keep the cables in place as so they wont go furher back when you push a male pin inside

after this you can put the top part to conectr with the main one or you can use 2 scres on the sides if there isnt enough friction inbetween the 2 parts

thats it now you have a very versetile 3.7v battery charger wich always comes in handy especialy for seeing battery persentages of batteries or charging them,

SIDE NOTE!

you can also use the pcb as a makeshift battery charger for any other project so you wont have to buy any modules online