I made this bracket to hold up a drop leaf table to give it more support. Since I was using standard Ikea legs, I wanted to use the existing screw mount and just needed a bracket to reasonably hold it in place (depending on the orientation of the bracket) without needing to screw it in.
The thicker pylons for the screws were to accommodate the screws that came with the legs and the desk top I was using.
I just printed this normally without supports and standard PLA with 0.2mm.
https://www.reddit.com/r/ikeahacks/comments/1clta2h/comment/mx0yvk1/?context=3
The author marked this model as their own original creation.