Pixel Watch 2/3 charging stand

More stable, but no windy, version of Felix's brilliant original design. I wanted something that was more stable for use at home rather than travel

If your printer is tuned it should print fine without supports, but adding supports only takes a few extra mins, and I would use Slim Tree support

The fit for the charger unit is quite tight and gives a satisfying ‘Click’ when pushed it. You can push it out using the cable hole

The cable in the bottom just needs gently persuading into the channel

Rebuilt in F360 from a small, profile, section where the charger sits from Felix's awesome design. I really like the original as a travel charger, but wanted something a little more stable for my bedside