Gremishka Swarm + Variants (DND / TTRPG)

More Gremishka models. Again I'm not suuuuper happy with the sculpting but the prints so far are turning out really nice. Small creatures don't have a TON of room for details - that being said I did add a fair amount of scarring to these different variants. The variants are all just different armature poses, some tail variants from a curve and then some minor sculpting "damage" added. I imagine these little critters are rough on each other as they would be to wandering adventurers.

Similar to the other Gremishka model I have the main ones on 20mm baseplates and I've added the swarm to a 25mm baseplate - I put them on a sort of "mound" to fill in the internal void and "avoid" supports in there.

I used blueprint studio for auto supports again. I'm happy with this in my workflow. I do need to off my butt and start doing resin prints again. For FDM printing you can print these straight up with minimal supports or at -90 degree tilt on the x axis (which is a generally a best practice). For these small models I recommend printing at 0.2mm because of the wispy tail otherwise you'll run into empty layer warnings. You can play with the tilt to address these issues though. Supports are a bit gnarly here so it might be best to print the baseplate separately on FDM.

Quick Edit: Added a higher res version which I then decimated - the topology isn't as tidy but it's a bit better looking imo. Still has the same print-ability challenges on FDM tho