Voron 2.4 X Carriage Eddy for StealthBurner HF/UHF

Description

This is a custom X-carriage designed specifically for the BigTreeTech Eddy Bed Level Sensor, based on the original Voron 2.4 X-carriage.

Instead of the standard probe mount slots, this remix uses insert nut positions, allowing you to mount the Eddy probe either higher or lower — depending on your hotend setup (HF / UHF → V6, Volcano).

The result: the Eddy probe sits 2.5 mm above the nozzle tip, which appears to be the optimal offset for reliable operation.

Personal Tip

When calibrating Eddy with Klipper:

• Set the current to 16
• Preheat your bed to a moderate temperature and let it settel for a few minutes before probing

This improves probe consistency across different bed temperatures.
I personally recommend using Eddy only for mesh generation, and relying on your hardware Z endstop or Voron Tap for general homing.

Note: If you're using a magnetic Hall sensor as your X endstop, you'll need to add a hole for the magnet — the screw position has shifted slightly compared to the stock design.

Klipper Config:

[probe_eddy_current eddy]
...
reg_drive_current: 16
x_offset: 0
y_offset: 21.5
z_offset: 2.5
...

BOM (Bill of Materials)

• 8× M3×5×4 heat-set inserts
• 2× M3 nuts
• 2× M3×30 mm socket head cap screws (SHCS)

Love my 3D models? 

If my designs have helped you print something awesome or inspired your next project, consider supporting my work! Your kindness fuels my creativity, keeps the filament rolling, and helps me share even more free/pay-what-you-want models in the future. Every coffee counts! 

→ Buy me a coffee ☕☕☕

• Fixed Mount Holes for BigTreeTech BTT Eddy probe
• Shifted lower screw