Voron Tapchanger Endstop XY

XY endstops for Voron Tapchanger.

Y endstop is adjustable

X endstop is fixed but you can adjust it if needed by printing another lever. 

• If the endstop is not activated you can print +1 // +5. This lever is 0.1 // 0.5 longer which means it will activate the endstop sooner.
• If there is room between the toolhead and the end of the X axis you could print -1 to -5. This lever is 0.1 to 0.5 shorter which means it will activate the endstop later.

Hardware:

• 3x M3x8 SHCS Two of them to hold the XY endstop mount to the gantry. One to hold the lever to the shuttle.
• 1x M3x10 SHCS To hold the Y endstop mount.
• 4x M2x10 self tapping screws. To hold the microswitches.
• 2x microswitch.
• 2x M3 heat insert. One for Y endstop mount. One for the shuttle, in case you had not inserted before.

Printing. Use standard Voron PFI settings. “XY_endstop_mount.stl” needs support.

This is designed for Voron Tapchanger but you could design another lever for other toolhead.

Added endstop for X