KLP1 210 Simple LED housing W.I.P.

A simple LED housing for KLP1 210 W.I.P. (Work in progress)

This is a working prototype, it will (most likely) improve in the future.

Housing for LEDs of maximum width of 85mm. 

For 1 euro you can get 2m/5m of cold white 5v usb LEDs on aliexpress.

Cut the strips of LEDs according to the length of the housings (right before the screw holes in case of side panel housing | Fully in case of the top housing)

Cable length should be around 9.5-10cm (Feel free to experiment with the length)

Side housings fit onto the side panel screws. (Because of bad quality of kingroon I couldn't take exact measurements of the distance between screws. But this should make it more universal.) You might need to replace the screws to longer ones for better fit or hot glue it in place as I did.

As for the top housing, it fits in the space on top of the door (should snugly fit. If it cannot fit, offset the part in the slicer for less Z height)

No supports required. Photos of printing orientation included.