Wet stone sink holder

Extra hardware required:

• 3/8" threaded rod (I used 16 thread per inch stainless. stainless is expensive, but  is best for the wet application)
• 8 3/8" nuts to match rod (again… 16 tpi stainless)

Printer, material, and settings

• bambu lab A1 with 0.6 mm nozzle
• translucent PETG (better for strength but PLA should work fine given right settings)
• 30% infill with 5 layer perimeters

4 of the nuts are to sure up the sink mounts. However, I cut the rod to a pretty tight fit, so the weren't necessary. There is 0.1" between the bottom of the sink mount rod holes and the face that touches the sink. So the rod will need to be cut at least 0.2" narrower than your sink is.