Sovol SH01 PTFE guide and riser

Here is an improved version of my PTFE guide for the Sovol SH01 dryer.

The goal was to remove the hinge of the original lid and have an easy on, easy off lid that I can just take off even when filaments are inside the dryer.

You just need to print 2x snap fit PTFE guides and slide your PTFE tube and filament through the hole.

Then install the lid spacer by closing the hinges and inserting the original hinge rod back in place.

You'll need to remove the hinge rod, for that I used an M3x40 screw and hammer to hammer it out. 

Look out for the orientation of the rod, there are press fit ribs on one side, obviously push the rod from the opposite side to get it out. 

In order not to break the plastic, I used a 47mm high block of wood in which I drilled a 4mm hole for the rod to go through. 
I placed the dryer to the side resting on the wood, that provided good support to the plastic hinge while hammering the rod out. Worked like a charm with no damage ! 

Printed on Qidi XMAX 3, Sunlu White PETG, 3 perimeters + 30% infill.