Small Camera Grip - 3M mount

This small pill shaped camera grip was designed to help with the ergonomics of the Panasonic Lumix S9 however should fit well on similar camera bodies as well. There are a few versions attached. 

1. TextureHandle_Recessed
   1. This adds a leather texture to the grip that does a great job hiding layer lines and matching the pattern of some cameras. Use the best quality you can on this. Takes about an 1hr to print for me
   2. Recessed space on the bottom makes room for 3m adhesive to help make the grip mount flush. How well this works is really dependent on how thick your adhesive strip is.
2. TextureHandle_flat
   1. This adds a leather texture to the grip that does a great job hiding layer lines and matching the pattern of some cameras. Use the best quality you can on this. Takes about an 1hr to print for me
   2. will be a small gap between camera and grip as there is not a recess built in
3. PlainHandle_flat
   1. This can be printed in about 5 minutes laying flat and does a pretty good job
   2. will be a small gap between camera and grip as there is not a recess built in

Hope you enjoy!