Federal Signal Model 2 - Printable (V4)

~ 1/2.5 scale
Made COMPLETELY on Tinkercad (including chopper): https://www.tinkercad.com/things/bXrYOfCuO9e-fs-model-2
PRINT ALL PARTS SEPARATE
DO NOT PRINT THE FULL MODEL, IT IS THE FULL MODEL LIKE THE PICTURES AND CANNOT BE SEPARATED
The stator and rotor should fit inside the housing with compatibility with an XD-775 (single shaft, 8000 RPM 12VDC) model DC motor. This motor should also fit inside the housing and below the core.

Link to potentiometer (to limit revs to ~7000): https://tinyurl.com/hcrzp5zh
Do not scale anything in Cura. (12% infill recommended.)
Link to EXACT motor, refer to picture with the specifications: https://tinyurl.com/3cbmknhp