Adjustable furniture feet 60-120mm

The adjustable thread part is printed flat to make it very strong. Yes, I dont need to make it flat on both sides as only the bottom side need to be flat, but I like when it's symmetrical.


Use Ø4-5mm screws for the “red” part that goes under whatever you want to raise. 
I used Essve 50x5.0 wood screws


No hardware required to assemble the foot

Instructions for the foot

as a Youtube short or in written form under the video: 

1. Part 1 is screwed into part 2 (no need to tighten hard, its only to keep part 1 in place, but make sure there's no gap)
2. Part 3 is placed over part 1 with the flat spot down and so it will fit into the slot (you can look at image 3 to see if it correct)
3. Part 4 is screwed on to part 1, to secure part 3 (this need not to be very hard tightened either as its only to keep the leg together)