Biohazard valve cap

General:

 A simple valve cap with Biohazard valve cap with built-in threads. 

Why I designed this:

I designed this as a fun experiment with small threads and small detailed MMU designs. 

Printing notes:

Layer height: .15 or finer is ideal

Recommended Material: PLA or better(depends on your climate. ASA will hold up better)

Supports: None

Infill: Any

Walls: 2-3

Other Modifiers: Print as oriented

Material Quantity: ≈3.8 grams per set

I printed from PLA on Prusa XL 5t at .15 layer height with 15% rectilinear infill.

Cautions and updates:

If the threads are too tight, adjust your XY compensation value. For me they were perfect and strong as-is with stock settings.

_____________________________________________________________________________________________________________

Don’t forget to follow me, post a make, leave a like, or tell me what you don’t like so I can make improvements.

Thanks, and Happy Printing!

Also check out:

https://fabtechmfg.square.site/

Added graphic. did not knurl exterior