Ethernet Mount for HP T620

Description

This Holding part allows for a second Ethernet jack to be mounted within an HP T620 enclosure.

This is needed, if the thin-client is used as a router (Example: pfsense). This plug replaces the Serial or VGA port on the device.

Needed Material

• 1x Ethernet Adapter (https://www.amazon.de/dp/B0788DG7NQ)
• 2x 3,5x10mm self tapping flat-head screw
• 1x “Holder”
• 1x “Retainer”

Printing Instructions

• No Special requirements

Building Instructions

1. Remove plug on the RJ45 board and solder the cables directly to it
2. Cut the RJ45 PCB to size (be careful not to damage anything)
3. Open device housing and remove Serial/VGA plug
4. Enlarge hole to fit new plug
5. Insert PCB into the holder and mount it into the thin-client with the two screws and the retainer
6. Close the housing again

Additional Information

This part was designed with Onshape.

You can also check out my Thingiverse page: https://www.thingiverse.com/a14x/designs