Spray Can Holder for Square Holes / Pegboard

To attach it to a pegboard you need to bend it to its place! 

That was to assure it won't get removed accidentally when a spray can is taken from it and it fits snug against the pegboard.

Fits the original “rings" from the original modeler, The bottom ring just needs to be slid in from the side.

Mine is made using PLA+ but basic PLA or PETG should also work. I printed it sideways laying on the bed without any supports.

Square holes of our pegboard is 8.5mm x 8.5mm 

I loved the look and functionality so i decided to modify it to fit a square holed pegboard my family member has in his garage. 

Has two hook points where it gets attached from.